Do the same for the other wing side
2.4. Nose unit connection
Put out the keel tube stinger
Open wings as far as possible – hardware at nose must join. If the nose ear does not match into the nose
fork, turn left and right keel beam to adjust position of the ear, corresponding to the fork
Insert nose pin. To do this, stand at the keel beam side, moving the keel beam slightly
Insert safety ring into the nose pin. Insert nose tube and secure it with the nose pin ring.
Put in the keel tube stinger
2.5. Install left and right trailing edge tube on the keel tube
2.6. Fasten root zippers on the upper and lower sail by 1/3 of their way
2.7. Install winglets
Screw out the head from winglet stud
Put the winglet on the tip so the stud will go through the hole in the tip
Screw the head on the stud and tighten it (winglet must not move on the tip)