1
Quick Start Guide
1.
Unpack monitor and check supplied components are correct
2.
Insert Battery (see page 6)
3.
Insert Sensor
4.
When new, plug in the power adaptor and turn on your monitor (with
sensor head installed) for 24hrs. Note: The Ni-MH battery requires
15hrs from full discharge and Lithium 3 hrs. The sensor requires a run
in period. Thereafter, the normal warm up takes only 10 minutes. If
your unit is new or unused for a long period, a warm up message may
display for several hours, then will disappear.
5.
Follow the operating instructions to understand how to make the
most of your monitor
CLOCK SETUP:
To
adjust the time, use the ar-
rows , pressing to alternate between hours, minutes, seconds, and the date. For more
information see page 13 of your user guide.
LOGGING SETUP:
To adjust the logging frequency, use the arrows , then press to
return to the main menu. For more information see page 18 of your user guide.
ALARM POINTS:
To adjust the alarm points, use the arrows , pressing to alternate
between alarm high, alarm low, and buzzer enable / disable. For more information see page 14 of your user
guide.
CONTROL POINTS:
To adjust the control points, use the arrows , pressing to alter-
nate between control high and control low. For more information see page 17 of your user guide.
UNITS:
To change the units of measurement, use the arrows , then press to return to
the main menu. See page 19 of your user guide for more information
MAX / MIN AV:
To adjust the max / min av, press to alternate between start and stop. See page
25 of your user guide for more information
Warning:
Do not
expose the monitor to gas concentrations above the recommended
maximum range
Do not
place the sensor head in a gas stream – the monitor is designed to
measure ambient levels of ozone and uses
„active sampling‟
to achieve this.
1.
Sensor Head
2.
Power and Stand By
3.
Display
4.
Alarm Mute
5.
Enter
6.
Scroll up, or hold down for data logging
(S500 only)
7.
Scroll down, or hold down for max/min
average
8.
Battery case. For battery installation, see
page 10 of your user guide