3
Air Brad Nailer F50RC
www.aeroprotools.com
DANGER!
Potential hazard that will result in serious injury or loss of life.
Keep children away from the work area. Do not allow children to handle power tools.
Keep air hose away from heat, oil, and sharp edges. Check air hose for wear before each use and ensure that all
connections are proper.
Always ensure that the workpiece is firmly secured leaving both hands free to control the tool.
Always ensure that the tool has stopped before putting it down after use, in the interest of safety and to prevent
possible damage to the tool/user.
Keep proper footing at all times in order to ensure correct balance.
Do not use oxygen or any other combustible or bottled gas
to power
air-powered tools. Failure to observe this warning can cause explosion and
serious personal injury or death. Use only the compressed air to power the
air-powered tools. Use a minimum of 25
’(7.6m) of hose to connect the tools to the
compressor. Failure to comply will result in serious injury or loss of life.
Risk of electric shock:
Do not expose a compressor to rain. Store it indoors.
Disconnect the compressor from power source before servicing. Compressor must
be grounded. Do not use grounding adaptors.
Risk of personal injury:
Do not direct compressed air from the air hose toward the user or other
personnel.
Risk of inhalation:
Never directly inhale the air produced by the compressor.
Risk of bursting:
Do not adjust the pressure switch or safety valve for any reason. They have been
preset at the factory for this compressor
’s maximum pressure. Tampering with the pressure switch or
the safety valve may cause personal injury or property damage.
Risk of burns:
The pump and the manifold generate high temperatures. In order to avoid burns or
other injuries, do not touch the pump, the manifold or the transfer tube while the compressor is running.
Allow the parts to cool down before handling or servicing. Keep children away from the compressor at
all times.
Risk of bursting:
Make sure the regulator is adjusted so that the compressor
outlet pressure is set lower than the maximum operating pressure of the tool.
Before starting the compressor, pull the ring on the safety valve to make sure
the valve moves freely. Drain water from tank after each use. Do not weld or
repair tank. Relieve all pressure in the hose before removing or attaching
accessories.
WARNING!
Potential hazard that could result in serious injury or loss of life.
Do not allow unskilled or untrained individuals to operate the air powered tools.
Do not use the air powered tools for any task other than that it is designed to perform.
Do not use the air tools unless you have been trained to do so. Only a qualified person should use the tool.
Locate the compressor in a well-ventilated area for cooling, and must be a minimum of 12
”(31cm) away from the
nearest wall.
Protect the air hose and the power cord from damage and puncture. Inspect them for weak or worn spots every
week, and replace them if necessary .
Always wear hearing protection when using the air compressor. Failure to do so may result in hearing loss.
