Press
magazine latch button
and pull magazine open.
Close
magazine.
Load
nails with points all the
way into the groove.
2
Attach
air
hose to regulator
outlet.
Adjust
regulator knob so
outlet pressure is
between 60 psi and
100 psi.
1
Close
pressure
regulator,
Turn
ON
compressor and
Allow
tank to reach
maximum pressure.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
Setup
Like a Pro
CHN70200 — Air Powered Brad Nailer
Attach
coupler on air
hose to nailer inlet.
4
2 inch Brad Nailer
CHN70200
IN728001AV 6/09
Setup
Like a Pro
Easy Setup Guide
Projects are easier with
Campbell Hausfeld
products.
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects
Like a Pro
.
Load
fasteners. See manual for further information regarding length and type
of fasteners.
3
© 2009 Campbell Hausfeld/Scott Fetzer
© 2009 Campbell Hausfeld/Scott Fetzer
Always disconnect the tool from
the power source when unattended,
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
Battery Replacement
60
psi
100
psi
Screw
Visit us at
chpower.com
