aero-naut Jonny, User Manual

Page: 10 / 40

Assemble the foredeck emergency exit by gluing together parts 99 - 103.
Two switches with 6 mm shafts can be installed in the floor 99, e.g. for activating
the model batteries.
Glue the hinge components 104 to the cover 105. Bend the handle 106 to the
shape shown, and glue it in place. Connect the cover to the housing using the
hinge pin 107.
106
105
104
102
100
101
100
107
103
At this stage the hull and deck can be painted. Place the model in its stand in the position shown in the drawing, and mark the Construction
Water Line (CWL) all round the hull. Mask off the threaded part of the propeller shafts. The model can now be painted in the colour scheme of
your choice. Glue the bollards and the exit hatch on the foredeck.
Deckhouse
Leave the window blanks in the sheet panels for
the moment; this eliminates the tedious task of
masking off the inside and outside when painting.
Do not remove the small tabs in the windows, as
they serve as spacers when fitting the glazing
panels later.
118
95
112
113
114
117
116
115
113
121
110 (111)
109
108
120
30
31
32
Complete the connecting wall 108 by fitting the doors 109. Glue this assembly in
the wall 82.
Complete the rear superstructure wall 110 with the doors 111, and glue it to the
floor 65 and the wall 108. The outer wall 113 of the exhaust pillar fits in the
same slot from the rear.
Tape the outer walls 113 and 116 of the exhaust pillar, and angle them slightly.
Glue them to part 110.
Fit the rear wall 114, and glue the doors 115 at the bottom.
Insert the lower wall 116 and the glazed wall 117 between the walls of the
exhaust pillars.
Tape parts 116 and 117 together, and glue these two walls to the floor 65 from
the inside.
Tape together parts 114 and 117, and glue the joint on the inside. Remove the
tape when the glue has set hard, and seal the narrow gap on the outside with
UHU Plast Spezial. The small nozzle of the adhesive bottle helps to keep the glue
in the correct place.
Fit part 119 (servo mount) in part 113. Insert the outer wall 120 and the
companionway support 121, then glue all the joints.
112
114
113
119
65
108
111
110
82
109
Assemble the fire-fighting bridge from parts 128 -
131 as shown in the drawing alongside.
Glue the bridge to the exhaust pillars.
The superstructure can now be painted.
130
129
131
128
Assemble the four cylinders from parts 126 / 127 as shown in the
drawing.
127
126
Glue the frames 123 to the exhaust pillars.
Glue the lugs 125 to the covers 124.
Drill 1 mm Ø holes in the pillars for the wires 127, adjacent to the
frame.
When the cylinders are complete, the covers can be glued to the
pillars.
If you wish to paint the grilles 208, do this before installing them.
125
124
127
123
208
126
33
34
35
36