30
English
AGLL10/20NFJ 07/11_4528571_00
AUTOTEST
The activation of the ventilation and the
valve of the branch corresponding to
the operating season, even in unsuitable
water or environment temperature
conditions, can be "forced" in the self-
test mode so as to verify the correct
functioning of the connections and the
windings of the electric motor.
PROBE READING
Values of the temperature probes
acquired by the electronic card can be
viewed through the yellow and red LED.
In this mode the card enters in the Probe
Display mode. Initially the card displays
the value of the Ambient probe SA.
Press the AUX key normally to view
other probes. The number of flashes by
the green LED indicates which probe is
displayed (see table).
Green LED
Probe displayed
2
SW probe
3
Aux SW probe
4
SA probe
5
Resistor probe SR
ALARMS LOG
The receiver cyclically indicates the last
5 alarms occurred on the machine in the
"alarms log" view mode:
• yellow LED:
cyclically flashes 5 times,
and then remains off for 5 seconds
•
red LED
: lights at the same time as the
yellow LED thereby providing a specific
code
ALARM
VISUALISATION
No alarm
Air probe faulty
Anti-freeze
Insufficient water
E4 interface not connected
Inverter fault
Resistor fault
condensate discharge
Motor fuse
Non-encoded signals
Key
Yellow LED
Red LED
Autotest
Pressing
of the
AUX key
Pressing
of the
AUX key
Pressing
MODE
SELECT
Pressing
MODE
SELECT
Pressing
of the
AUX key
V1
ON
V2
ON
V3
ON
Autotest Off