USER MANUAL
COOLMAX SRX – Wall Mount
Australian Energy Research Labs
AER09 – Rev 1.2.3
31
st
October 2022
12
AER09 REV 1.2.3
To install cabling, the access panel of the COOLMAX SRX must be removed. This is done by removing the
two M4 countersunk Phillips screws on the bottom of the enclosure and the four M3 countersunk Phillips
screws on either side of the access panel.
Refer to Figure 2 below.
Figure 2:
SRX Access Panel Screw Locations
CAUTION – Hazard
All CoolMax SRX wiring must enter the unit through the entry ports located in the base
and rear of the enclosure.
Under absolutely
no circumstances
should holes be drilled anywhere into the unit to
make other cable entry points. Doing so can cause metal swarf or fillings to enter the
internal electronics and damage the unit once powered up.
Drilling any holes into the unit will void all product warranty.
Wiring Compartment
