Aeris F10, Operating Manual

Page: 72 / 84

72
• Closely examine the Battery Hatch and Housing for any
signs of damage that might prevent proper sealing.
• Closely examine the inside of the Battery Compartment for
any signs of corrosion indicating entrance of moisture into
the unit.
• If corrosion is found, return the F10 to an Authorized
AERIS Dealer, and DO NOT attempt to use it until it has
received factory service.
• If moisture is found, it is best to have the unit inspected
and cleaned by an Authorized AERIS Dealer.
Battery Installation
• Slide a new 3 volt type CR2430 Lithium Battery, negative
side down into the Battery Cavity. Slide it in from the Left
side (Fig. 70) and ensure that it slides under the contact
clip on the lower/right rim of the cavity.
• Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch. Ensure
that it is evenly seated (Fig. 71).
NOTE: The Hatch O-ring must be a genuine
AERIS part that can be purchased from an
Authorized AERIS Dealer. Use of any other O-
ring will void the warranty.
Fig. 70 - BATTERY
INSTALLATION
Fig. 71 - BATTERY
HATCH O-RING