18/28
TF6751_D
Aereco S.A.
11) Attach the fan to its specific adaptation using 3 x Ø 8 mm stainless steel washers.
Note: The 2 handles can be removed by pinching them; this eliminates a potential source of noise due to mechanical
vibration.
12) Position the control unit at least 50 mm from the fan.
Choose the side facing North to reduce the influence of direct
sunlight.
It must be positioned so that the cable connecting the fan to it is not loose. If necessary, fit cable clamps.
- Loosen the M6 screw that are maintaining the support
plate to the fan
’s body. Remov
e the magnet located on
the protective metal cover back.
▪
- Fix the base of the metal protection using the screws
supplied either vertically or horizontally.
▪
- Remove the magnet located behind the box metal
protective cover
▪
- Loosen the 4 screws that are maitaining the protective
driver box to the plate support.
- Set the plate on the plenum
- Put back the support box horizontally or vertically by
tightening the 4 screws
