7
5.5 Electric Connections
The unit must be earthed.
The QR200A is wired internally from factory.
Figures below show the wiring diagram.
WARNING
Make sure that the mains supply to the unit is disconnected before performing any installation, service, maintenance or electrical work!
WARNING
The installation and service of the unit and complete ventilation system must be performed by an authorized installer and in accordance with local rules and
regulations.
SLAVE input
1-10V
J2 jumper for SLAVE mode
AC power supply
Bypass shutter supply (BPS)
(230Vac 5A)
Heating output
(max 250Vac 5A)
Dehumidifier output
(max 250Vac 5A)
Boost momentary
switch (BST)
IAQ input
(Air Quality
i.e. CO2)
HY input
(i.e.Humidistat)
CTRL-DSP
Inputs/commands
N°1 AC supply connector
N°3 on/off inputs (volt-free contacts), two for ambient sensors (named HY, IAQ) and one for boost momentary switch (named BST).
N°1 1-10V analog input (named SLAVE).
N°1 jumper for SLAVE MODE selection.
N°1 4-pole connector for CTRL-DSP (RS485 plus 12Vdc supply).
Outputs
N°1 on/off output for bypass shutter (commuted 230Vac supply).
N°1 on/off output for pre-heating/post-heating (relay contact – 250Vac 5A).
N°1 on/off output for dehumidification (relay contact – 250Vac 5A).
Fig. 5.f Electrical connections on the motherboard fitted in the connection box
+12V
A
B
GND
A
B
1
2
V
G
N
D
Summary of Contents for QR200A
Page 23: ...23 NOTE ...
