Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user
needs or unlock further enhanced features.
IMPORTANT:
Controllers may only allow to configure signed values. In order t
o set values in the range 128 … 255 the value sent in the
application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of 200 minus 256
= minus 56. In case of two byte value the same logic applies: Values greater than 32768 may needed to be given as negative values too.
Enable/Disable waking up (Parameter Number 2, Parameter Size 1)
Enable/Disable waking up for 10 minutes when re-power on (battery
mode) the MultiSensor.
Value
Description
0
disable (Default)
1
enable
default PIR time (Parameter Number 3, Parameter Size 2)
The default PIR time is 4 minutes. The Multisensor will send BASIC SET CC
(0x00) to the associated nodes if no motion is triggered again in 4 minutes.
Value
Description
10 —
255
The time unit is second if the value range is in 10 to 255. Default Value is 240.
256 —
3600
If the value range is in 256 to 3600, the time unit will be minute and its value should follow the below rules: a), Interval time =Value/60, if the interval time
can be divided by 60 and without remainder. b), Interval time= (Value/60) +1, if the interval time can be divided by 60 and has remainder. Other values will
be ignored.
Enable/disable the function of motion sensor. (Parameter Number 4, Parameter Size 1)
Value
Description
0
disable (Default)
1
enable, the current PIR sensitivity level=1. (minimum level)
