DM482e User Manual
AEMULUS
13
Item
Description
1
Select the PXI address of the module. A list of addresses is shown for all detected
modules in the chassis.
2
Select the pin group.
3
Set the number of power line cycle, in second.
4
Set the frequency of the power line (50Hz or 60Hz).
3
Initialize the selected module. This includes opening a session to communicate with
the module, and then reset the module in its default state
5
Un-initialize the selected module. This includes closing the current communication
session to the module.
6
Per Pin Parametric Measurement Unit (PPMU) function:
a
Output Function
DC DVCI
: Drive-Voltage Clamp-Current operation.
Continuous mode.
DC DICV
: Drive-Current Clamp-Voltage operation.
Continuous mode.
b
Voltage Level
Voltage level
c
V Range
Range of the voltage level
d
Current Level
Current level (Current level setting is not required
in DVCI mode. “I Range” will decide the
compliance value)
e
I Range
Range of the current level
f
Sense
Select either
Remote
or
Local
sense connection
6a
Click the “Start” button for the selected pin to execute PMU commands. The
button will immediately turn to “Stop”. Press it to exit from PMU functions.
Following results are shown for each pin:
a.
Voltage (V)
b.
Current (A)
c.
On-board temperature
