12
·
Status LED indicates power & GPS signal
·
Weather resistant enclosure with IP67 rated GPS/GLONASS antenna
Go to
Setup | Lap Timing...
Select the GPS button to configure for
GPS lap timing. A virtual start/finish line creation feature allows you
to use the beacon input (violet wire in flying lead harness) to set a
virtual start/finish line. While driving the course, press the momentary
beacon switch when you cross the start/finish line. Hold for a few
seconds until the left and right LEDs flash. The system captures the
location information when you first press the button. Holding for a few
seconds eliminates the likelihood of false triggering the input. You
can define your virtual track width in the dialog window. Set to the
approximate width of the track surface plus some extra. The dash
creates a start finish line the width of the track perpendicular to the
heading when the start finish is set. It then checks whether the
previous two points cross this line; the only caveat being that the
heading is +/- 90 degrees of the original heading.
Installation
