20
9
5. Standing
Do not switch on the power after the refrigerator is placed, leveled and cleaned. Switch on the
power after it is put on standing for more than 24h, to ensure normal performance of refrigerator.
6.Installation Rack and Price Card
Take out the rack, price card and rack fastener from the
refrigerator. Fix the rack fastener on the rack at the
appropriate distance and height. After mounting the rack
and price card, place them on the rack fastener and ensure
the rack is placed flatly and firmly.
It is necessary for the user to install remote alarm device to the remote alarm
switch by himself
In case of power failure, a fully charged backup battery enables the alarm
function to keep working for 48 hours. The initial operation requires the
refrigerator to run at least 2days in a row, while the backup battery needs to be
charged for the initial operation or after a long time of power failure.
The buzzer beeps 3 times in 1Hz continuous sounds for every press on the
“Alarm Test ” key, with the alarm indicator flashing 3 times, if under non-remote
hardware alarm conditions, remote alarm relay disconnect after connecting 3s
alternatively, then alarm action may triggered depending on actual requirements.
This shows the alarm system is under normal condition.
When chargeable battery is closed or with too low a power, press once the alarm
testing key, E6 is expected to flash 3 times on the display window at the
simultaneously.
The refrigerator shall be charged by special personnel that inspects and records
its operating conditions every day, if too high or low a temperature is observed,
the articles in it shall be transferred to others until it is again under normal
conditions.
In case of an alarm, you can press the key “Silence” on the display panel to stop the alarm.
(The remote alarm will not be stopped.)
If the alarm condition still exists, the buzzer will make an alarm again automatically 30min. later.
Automatic Alarm Recovery
This series of refrigerators has the automatic alarm recovery function:
Remote alarm terminals are installed on the
refrigerator and the alarm signal behind the
compartment is output by the terminals. The
bearing capacity of the terminals is DC 30V, 2A.
Terminal output:
Remote alarm terminals include NO, NC and COM.
The user can choose “NO” or “NC” if needed.
Remote Alarm Terminals
COM
NO
NC
Fig.4
Fig.5
7. Installation of the Handle
Handle installation of products shall be conducted
in the following steps:
①
. Orient the handle with the hole downwards
；
②
. Align the handle and handle guide on door;
③
. Uphold the handle after the handle is locked with the
handle guide;
④
. Use bolt to fix the handle from bottom after tight
installation of the handle.
1
3
2
4
