50
Switching on the appliance
0
While spray vacuuming and afterwards the room should be well aired in
order to facilitate rapid drying.
0
The rocker switch must be pressed in the
direction of the spray suction nozzle symbol
”
”. Plug the cable into the power outlet: To
switch the appliance on, turn the rotary switch
to the ”I” symbol.
The rocker switch will illuminate.
Spray vacuum cleaning of carpets
0
Place the spray suction nozzle for carpet on the
carpet in one corner of the room. Press and hold
down the valve handle located on the handle
until the cleaning liquid is sprayed onto the
carpet. Then slowly pull the nozzle that has been
placed on the carpet in a straight line across the
carpet in the direction of the arrow. The
cleaning liquid which has been sprayed into the
carpet pile is vacuumed up together with the
released dirt in the same step. In this way the carpet becomes damp,
but not wet through.
0
At the end of the strip of carpet, or when pausing, release the valve
handle in order to stop the jet of spray. When the liquid that has been
sprayed out is vacuumed up again, lift up the nozzle and begin
vacuuming a new strip of carpet with a small overlap. In this way the
entire area can be treated strip by strip. Should traces of liquid remain
on a strip of carpet that has been cleaned, these areas can be
vacuumed over again with the valve handle released. All that this is
doing is removing additional moisture from the carpet. The amount of
moisture extracted can be checked by looking through the transparent
top section of the nozzle. For a longer penetration time and in order to
achieve a certain soaking effect, the detergent can be applied with the
spray suction nozzle for carpet held above the carpet and then,
following a short soaking period, the detergent can be vacuumed up.
However, one must ensure that not too much liquid is sprayed onto the
carpet, as this could cause (according to the material) ripples or raised
areas to appear in the carpet.
Summary of Contents for VAMPYR Multi
Page 2: ...32 ...
Page 29: ...59 Wet and dry multi purpose nozzle ET no 668 900 830 Bevelled pipe nozzle ET no 668 900 828 ...
Page 30: ...118 ...
Page 31: ......
