15
■
Speed display
(Figure 1B)
"0" is shown as soon as the unit is connected
to the mains supply.
The pre-selected speed is displayed when it is
ready for operation.
"= =" appears if the operating tool is blocked.
■
ON/OFF button (Figure 1 C)
This button is used to switch the motor on and
off.
■
Buttons for adjusting the speeds
(Figure 1D)
They are used to change the speeds to a hig-
her ("+") or lower ("-") level. By continually
pressing this key the speed may be raised or
lowered in steps.
■
Pulse button (Figure 1E)
The pulse button may be used for momentary
operation of the unit at the respectively set
speed. The unit ceases to operate when the
button is released.
■
Automatic pulse button (Figure 1F)
The unit motor may be periodically switched
on or off at the respectively set speed. The
motor is stopped by pressing the button again.
■
Turbo button (Figure 1G)
While the motor is running the speed may be
briefly increased beyond the respective maxi-
mum level possible. The turbo function may be
used for a maximum of 25 seconds. After-
wards, the unit automatically switches back to
the original speed.
This is how to put your Multiple Use Appliance
into operation:
■
Place the unit on a dry and level work surface.
■
The cable storage compartment (Figure 1 H) is
located at the rear of the basic unit. Unused
cable may be stored here if the lead to the
socket outlet is too long.
■
Connect the unit to the mains supply. The ope-
rating display (Figure 1 A) is red. A "0" appears
in the speed display (Figure 1 B).
■
Selected the accessories and operating tool
suitable for the work intended.
Use of the All Purpose Bowl
(Figure 2A)
/Metal Blade
(Figure 2E)
/
Metal Plates
(Figure 2F-2I)
■
Attaching the all purpose bowl
Place the all purpose bowl (Figure 2 A) onto the
guide grooves in such a way that the marking
(
▼
/OPEN) on the bowl matches the (
▲
) on the
Multiple Use Appliance and turn the bowl in a
counterclockwise direction until the bowl beco-
mes latched (the symbol
▼
/CLOSED is located
above the marking
▲
on the unit).
■
Using the metal blade
Remove the protective cover before using the
blade.
Caution: metal blade is extremely sharp.
Danger of injury!
Place the blade into the all purpose bowl.
■
Attaching and locking the cover
Place the cover onto the guide lugs so that the
marking (
▼
⁄ OPEN) on the cover matches the
marking (
▲
) on the all purpose bowl and turn the
cover in a counterclockwise direction until you
feel the locating pin lock into the slot provided
for (Figure 1) (the symbol
▼
/CLOSED is located
above the marking
▲
on the bowl).
