AEG KKE884500, User Manual

Page: 7 / 24

6 7
EN
corresponds to the value indicated on the rating plate on the
bottom of the appliance.
Connect the appliance to an efficiently earthed and correctly in-
stalled socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified pro-
fessional.To comply with safety directives, an omnipolar switch
with a minimum contact distance of 3 mm must be installed.
Do not use multiple sockets or extensions.
Important! Safety cutout devices must be included
in the mains power supply in compliance with the installation
regulations in the country concerned.
Disposing of the appliance
The appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
USING THE APPLIANCE FOR THE
FIRST TIME
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee
in the mill.
• Customise water hardness as soon as possible following the
instructions in the “Setting water hardness” section.
1. Connect the appliance to the mains supply.
Set the required language.
2. To set the language, use the icons (B7 and B8) to
choose the required language (fig. 2). When the message
“PRESS OK TO CHOOSE ENGLISH” is displayed, press the OK
icon (B9) (fig. 3) for 3 seconds until “ENGLISH INSTALLED”
is displayed. If you set the wrong language, follow the in-
structions in the “Setting the language” section.
If your language is not available, select one from those dis-
played. The instructions refer to the English version.
Then follow the instructions displayed:
3. After 5 seconds, the appliance displays “FILL TANK”. Extract
the water tank (fig. 4), rinse and fill with fresh water with-
out exceeding the MAX line. Replace and push as far as it
will go.
4. Place a cup under the hot water spout (fig. 5). (If the hot
water spout is not inserted, the appliance displays “INSERT
WATER SPOUT”. Attach it as shown in figure 5.
The appliance displays: “HOT WATER PRESS OK”.
Press the OK icon (B9) (fig. 6) and after a few seconds a little
water comes out of the spout.
5. The machine now displays “TURNING OFF... PLEASE WAIT”
and goes off.
6. Extract the appliance by pulling it out using the handles
(fig. 9). Open the lid and fill the container with coffee
beans, then close the lid and push the appliance in.
The coffee maker is now ready for normal use.
Important! Never introduce pre-ground coffee, freeze
dried coffee, caramelised beans or anything else which could
damage the appliance.
N.B.! When using the appliance for the first time, you
need to make 4-5 cups of coffee and 4-5 cappuccinos before the
appliance gives satisfactory results.
N.B.!
Each time you turn the coffee maker on by the ON/
OFF switch (A23), it performs a SELF-DIAGNOSIS cycle and then
goes off. To turn it on again, press the ON/OFF button (A7) (fig. 7)
TURNING ON AND HEATING UP
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns! During rinsing, a little hot water
flows from the coffee spouts.
To turn the appliance on, press the ON/OFF/stand-by button (A7)
(fig. 7). The message “HEATING UP... PLEASE WAIT” is displayed.
When heating is complete, the message changes to “RINSING”;
The appliance is at temperature when the message “MEDIUM
CUP NORMAL TASTE” is displayed.
If no icon is pressed within about 2 minutes, the time (if set, see
the “Setting the clock” section) is displayed.
If the time has not been set, the appliance displays the last func-
tions set.
When any icon is pressed, “MEDIUM CUP NORMAL TASTE” is dis-
played again. The appliance is ready to make coffee again.
MAKING COFFEE USING COFFEE
BEANS
1. The appliance is preset to make coffee with a normal taste.
You can also choose coffee with an extra-mild, mild, strong
or extra-strong taste. There is also a pre-ground coffee op-