The heating element folds down.
3.
Clean the oven ceiling.
4.
Install the heating element in the
opposite sequence.
Install the heating element
correctly above the supports
on the inner walls of the
appliance.
5.
Install the shelf supports.
9.5
Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1.
Open the door fully.
2.
Fully press the clamping levers (A) on
the two door hinges.
A
A
3.
Close the oven door to the first
opening position (approximately 70°
angle).
4.
Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
9.6
Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1.
Turn off the oven.
Wait until the oven is cooled down.
2.
Disconnect the oven from the mains.
3.
Put a cloth on the bottom of the
cavity.
ENGLISH
25
Summary of Contents for EEB350010M
Page 1: ...USER MANUAL EN User Manual Oven EEB350010M ...
Page 29: ...ENGLISH 29 ...
Page 30: ...www aeg com 30 ...
Page 31: ...ENGLISH 31 ...