60
ENGLISH
7. Search and Edit Channel
Your TV set can receive DVB-T signals as well as conventional analogue signals (e.g. via cable). The stations which can be
received depend on the selection of the input signal: your DVB-T antenna for DVB-T reception or analogue cable tuner.
Both methods can be saved in the channel list – but generally you will only use one kind of reception.
• DVB-T channels are displayed as DTV in the OSD menu.
• Analogue channels are displayed as ATV in the OSD menu.
7.1 Channel Search
1. Press the
TV MENU
button to display the OSD main menu.
2. Press
in CHANNEL
menu to select
Auto Tuning
.
3. Press
OK.
Press / to select one of three tuning methods (DTV+ATV,
DTV, ATV). Now press .
4. Then press
to select the country as your location.
5. Press
OK
to start Channel Search. This will take a few minutes. The
progress is shown on screen.
6. After auto scan channel 1 is displayed.
7. The window closes automatically after a few seconds or press
EXIT
to close it.
7.2 DTV Manual Scan
1. Press the
TV MENU
button to display the OSD main menu.
2. Press the arrow button to select item
DTV Manual Tuning
and press
OK
.
3. Press the arrow buttons / to select a channel. The signal strength of the selected
channel is displayed. If no signal is received on the selected channel NO SIGNAL is
displayed. In this case select a different channel.
4. Press
OK
to start the manual scan.
5. After finishing the manual scan the number of found channels is displayed.
Press
EXIT
to close the window.
7.3 ATV Manual Scan
To receive analogue channels an analogue antenna signal (e.g. cable tuner) must be connected. Analogue channels are
displayed as ATV (TV) in the OSD menu. If previously DVB-T channels were saved the new analogue channel is added to
this list. The digital channels are not overwritten.
1. Press the
TV
MENU
button to display the OSD main menu.
2. Press
in CHANNEL
menu to select
ATV Manual Tuning
and press
OK
.
3. Under
Storage To
press / to select the position in the channel list for the new
analogue channel.
4. Press / to highlight
Search
.
5. Press / , to start the manual scan. The changing frequency is displayed during the
scan. After a channel is found the sound is activated again.
6. Press the
red
button to save the channel.
7. To scan for additional channels first select a position in the channel list for the new
analogue channel with
Storage To
and then restart the scan.
In this menu you can also perform the following settings:
System
: is generally not changed.
Current CH
: shows which
channel is active in the background. Press / to change.
Fine-Tune:
Press / to change the frequency in small steps.
Frequency:
Shows the current frequency.
7.4 Edit Channels
After auto scan all channels are saved in found sequence. You can add channels in the favourite list (FAV) or change the
sequence by moving/swap or skipping channels.
