--------------------------------------------------------------------------------9/39--------------------------------------------------------------------------------
3
4
5
1
6
Cable
7
4.4.2.2
Mounting of the cable
The cable must be mounten in following steps:
•
Remove all inner parts from the cable pipe at the SAB Cab (/) (nut (5), cable fastener (3), pipe(4))
(see Figure 4)
•
Put all the removen parts (nut (5), cable fastener (3), pipe (4),) ann the cable pipe of the SAB Cab
as well (/ to 4) to the cable.
Figure 4: Mounting for the cable
•
Remove the outer isolation of the cable at a length of 6 cm .
•
Remove the isolation of the wires at a length of 6 mm ann stick a covering hull to the litz wire.
•
Put the cable to the cable pipe. The length of the cable coming out the SAB cab must long enough to
no all further installation steps in an easy way.
•
Stick the pipe (4) into the cable fastener (3).
•
Stick the cable fastener (3) into the cable pipe.
•
Connect the cables into the right places of the MINI-COMBICON-Connectors (6).
•
The pin assignment is shown in the figure below.
•
Put the MINI-COMBICON-Connectors into the SAB cab. Look after the color coning.
