--------------------------------------------------------------------------------3/39--------------------------------------------------------------------------------
7./.5
Upper ann lower case ....................................................................................................................... 22
7./.6
Linefeen ........................................................................................................................................... 22
7.2
Instructions for the hardware settings...................................................................................................... 22
7.2./
ADR - profibus annress of the reaner ................................................................................................ 22
7.2.2
TERM - termination ......................................................................................................................... 23
7.2.3
TC – monitor function ...................................................................................................................... 23
7.3
Instructions for the reading settings......................................................................................................... 24
7.3./
GT – single transponner cone reaning ............................................................................................... 24
7.3.2
CID – Suppression of ID Cones ......................................................................................................... 24
7.3.3
CN – Suppression of No Reans ......................................................................................................... 25
7.3.4
NID – Failure Protection .................................................................................................................. 26
7.3.5
TOR – Maximum reaning time .......................................................................................................... 27
7.4
Instructions for the memory settings ........................................................................................................ 27
7.4./
VER – Reaner firmware ................................................................................................................... 27
7.4.2
VS – Show parameter ....................................................................................................................... 28
7.4.3
VSAVE – Save parameter ................................................................................................................ 28
7.4.4
RST – Warm start ............................................................................................................................ 28
7.4.5
INIT – Warmstart with nefault parameters ....................................................................................... 29
8
OPERATING MODES OF THE READER ...................................................................... 30
8.1
MD 2 - Triggered by an Software Command ............................................................................................ 30
8.2
MD 0 - Continuous Reading ..................................................................................................................... 31
9
STARTING UP AS PROFIBUS SLAVE ........................................................................ 32
10
BASIC DATA EXCHANGE PROCESS ....................................................................... 33
10.1
Selective read RD ................................................................................................................................ 33
10.2
Writing WD ......................................................................................................................................... 34
11
INSTRUCTIONS........................................................................................................ 35
11.1
General Instructions ............................................................................................................................ 35
11.2
Special Instructions for Using a Read / Write System .......................................................................... 36
12
CERTIFICATIONS .................................................................................................... 38
13
HOTLINE .................................................................................................................. 38
14
REVISIONS .............................................................................................................. 39
