AEG 79669GO-MN, User Manual

Page: 32 / 48

32
SOLVING PROBLEMS
Faults
If there is a problem with the oven and / or grill, please:
• Check the points listed below before calling for
service . It may be possible to avoid a call by fixing
the problem yourself – and so continue cooking .
NOTE: We may charge for service even in the
guarantee period if your problem is due to the causes
listed below.
Problem Possible cause What to do
Oven or grill not working Power not turned on . Switch on electricity
Household fuse blown Check fuses
Controls incorrectly set Reset controls
Circuit breaker tripped Check circuit breaker
Clock not set Set time of day on timer
Oven not heating enough Foil or trays on bottom of oven Remove foil or trays
Light and fans on continuously Timer not in manual mode Set timer to manual mode
Oven not working Timer not in manual mode Set timer to manual mode
Household fuse blown Check fuses
Oven light not working Household fuse blown Check fuses
Circuit breaker tripped Check circuit breaker
Lamp blown or loose in socket Replace or tighten lamp
Too much condensation building
up when baking
Too much water used when cooking Reduce amount of water
Leave oven door open after cooking
Cooker smells/ Smoking when
first used
Protective oils being removed This is normal . Turn grill on high for 30 mins
and then the oven on 220° for 1 hour
Timer flashing Power failure or interruption Reset time of day
Burner will not light even though
the sparker is working
Knob not held down long enough in ‘High’
position for flame safeguard to engage
Repeat lighting procedure and hold knob
down
for 5 seconds in ‘High‘ position
Gas supply valve turned off Turn on gas supply to appliance
Wrong knob turned off Ensure the knob you are turning corresponds
to the burner you want to light
Port blockage in ignition area Ensure the ports in the ignition area are
clean and dry
Ignition spark plugs wet or dirty Dry or clean ignition spark plugs
No spark is obtained when control
knob is activated
Electricity supply is disconnected or
switched off
Switch on electricity or check fuses
Ignition spark plugs wet or dirty Dry or clean ignition spark plugs
Flames uneven or tending to lift Flame ports blocked or wet Clean or dry flame ports
Burner incorrectly fitted Ensure this component is fitted correctly
Flames not staying on when knob
released
Knob not held down long enough in ‘High’
position for flame safeguard to engage
Repeat lighting procedure and hold knob
down for 5 seconds in ‘High‘ position
Knob not set between ‘High’ and ‘Low’ Knob MUST be set between these positions
Dirt or spillage on flame safeguard sensor Clean flameguard sensor tip
Low heat, slow cooking Incorrect cooking pot or pan being used Refer to cooktop section for correct
selection
Benchtop or knobs overheating Incorrect cooking pot or pan being used Refer to cooktop section for correct
selection
Pot or pan not located on burner properly Ensure pot or pan is centrally located on
burner
Limescale residue on base of
oven
Residual minerals from evaporated water Follow the procedure for cleaning the cavity
well . There may be some minor residual
marks after cleaning
NOTE: Only authorised personnel should carry out
servicing. If the household fuse continues to blow, call
the Customer Care Centre. In the event of a power
failure the gas burners may be lit with a hand held
igniter and used. Take care to avoid letting unburnt gas
flow for more than 5 seconds when attempting to light
the burner.