The other end of the inlet hose which connects to the machine can be
turned in any direction. Simply loosen the fitting, rotate the hose and
retighten the fitting, making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase a new, longer hose spe-
cially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with the
machine.
In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch.
This branch
must be above the trap so that the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a height
of not less than 60 cm and
not more than
90 cm.
The end of the
drain hose must
always be
venti-
lated
, i.e. the
inside diameter
of the drain pipe
must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
For a correct functioning of the machine the drain hose must
remain hooked on the proper support piece situated on the top
part of the back side of the appliance.
84
Installation
132981740_gb.qxd 16/05/2006 15.09 Pagina 84