You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by
carpets, rugs etc.
• Before placing it on small tiles, apply a rubber coating.
• Never try to correct any unevenness in the floor by putting pieces of
wood, cardboard or similar materials under the machine.
• If it is impossible to avoid positioning the machine next to a gas
cooker or coal-burning stove, an insulating panel (85x57 cm) covered
with aluminium foil on the side facing the cooker or stove, must be
inserted between the two appliances;
• The machine must not be installed in rooms where the temperature
can drop below 0.
• The water inlet hose and the drain hose must not be kinked.
• Please ensure that when the appliance is installed, it is easily accessi-
ble for the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the adjustable
feet in or out. Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
Connect the water inlet hose to a separate tap with a 3/4" thread.
The inlet hose is
provided with a
water stop device,
which protects
against damage
caused by water
leaks in the hose
which could
develop due to
natural ageing of the hose. This fault is shown by a red sector in the
window “A”. Should this occur, turn the water tap off and refer to your
Service Centre to replace the hose.
83
A
P0
35
2
Installation
132981740_gb.qxd 16/05/2006 15.09 Pagina 83