AE Techron LVC2016, Technical Manual

Page: 14 / 48

Pre-Installation 1-4
1.2.2 Specifications
Specifications are for units in Dual Mode driving both channels into 8-ohm loads,
(26 dB = 20 times voltage gain) and operating from 120 VAC, unless otherwise
specified.
•
Standard 1 kHz Power" refers to maximum average power in watts
at 1 kHz with 0.1% THD.
•
Full Bandwidth Power" refers to maximum average power in watts
from 20 Hz to 20 kHz with 0.1% THD.
Performance
Frequency Response: ± 0.1 dB from 20 Hz to 20 kHz at 1 watt.
Phase Response: ±10
°
from 10 Hz to 20 kHz at 1 watt.
Signal to Noise Ratio: At 26-dB gain, better than 105 dB (A-weighted)
below full output.
Total Harmonic Distortion (THD): <0.05% from 20 Hz to 1 kHz,
increasing linearly to 0.1% at 20 kHz at full output.
I. M. Distortion: <0.05% from 410 milliwatts to full output at 26-dB
gain, with an 8-ohm load.
Slew Rate: >13V per microsecond.
Load Impedance: Rated for 16, 8, 4, and 2-ohm use. Safe with all load
types, even reactive ones.
Required AC Mains: 60 Hz, 120VAC with 15-20A service. Other
voltages are available by special order.