27
Fill in the
Station Name
(name of the generating station or utility) and
Unit Name
(generator
1, or whatever the name is for that unit from that station).
Click on appropriate box to select type of the machine tested. This selection will affect data
display and printout, only. It is assumed that Turbo machines will have horizontal rotor (i.e.
in data display wedges will be shown horizontally) and Hydro machines will have vertical
rotor (wedges will be printed/displayed vertically). For Motors, select appropriate box based
on above description.
Optionally, you can add comments in the
Comments
box. Maximum number of characters
for
Unit Name
is 60, and for
Station Name
100. The following characters can not be used: \
/ * : ? “ < > |
Once the station and unit are created, the name will be saved in the station directory under
the ADWEL\Units directory, with a
cfg
extension.
The next tab is titled
Slot and Wedge Description
. In this tab you may fill in information for:
1.
number of slots in the machine;
2.
number of wedges per slot;
3.
wedge width;
4.
unit measure of width (mm, cm, inches);
5.
wedge and filler description;
6.
and comments, if any.
Figure 23: WTD Properties Slot and Wedge Description Tab
The third tab is the Nameplate information tab, and contains configuration information for
the unit, as displayed on its nameplate. The following information may be filled in:
Summary of Contents for WTD-501
Page 51: ...51 APPENDIX 1...