Advantech TPC-2000 Series, User Manual

Page: 12 / 74

TPC-2000 Series User Manual 4
1.5 I/O Port Arrangement
The arrangement of the I/O ports is shown in Figure 1.1
Figure 1.1 I/O Port Arrangement
1.6 Panel Mounting
1. There is an adhesive waterproof gasket on the Mg front bezel. Make sure the
waterproof gasket is in position before installing TPC into the panel opening.
2. Install the TPC into the panel opening.
3. Retrieve the clamps and long screws from the accessory pack. Hook the clamps
the holes located on the four sides of the bezel. Insert screws into every clamp
and tighten them to fasten the clamp in place. These screws will push the
mounting panel and secure the unit.
4. The suggested mounting panel thickness is less than 6 mm (0.236 in).
Figure 1.2 Panel mounting
Insert the screws into each clamp and tighten
them to fasten the clamp in place.
Hook the clamps into the holes and fasten the
screws
Torque: 2 kgf-cm
These screws will push the mounting panel and
secure the unit.