Advantech MIC-3397, User Manual

Page: 17 / 76

5 MIC-3397 User Manual
Chapter 1
H
ardware
C
onfiguration
Gigabit Ethernet port can be selected in the BIOS menu. These are mutually exclu-
sive and can be any one of:
 Front I/O (RJ-45)

Rear I/O (Rear Transition Module)
 PICMG 2.16
User can access LAN1 via front panel. LAN2 is accessible via front panel & rear I/O,
LAN 3 via rear I/O, LAN4 & LAN5 can be connected to PICMG 2.16 on backplane.
1.2.7 Storage Interface
The MIC-3397 supports four SATA II interfaces. The SATA1 interface can be routed
to an on board 2.5" SATA hard disk drive or one 8G on board NAND flash by switch;
the SATA 2 interface is routed to an on board Cfast module; SATA 3 & 4 are reserved
to rear I/O via J3 connector for user customization.
1.2.8 Serial Interface
Two serial ports are from Super IO and one from PCH. One RJ-45 COM1 port (RS-
232/422 interface) is provided on the front panel. Two COM ports (RS-232/422/485
interface) are routed to a rear I/O module as RJ45 or DB9 port via the J5 connector.
1.2.9 USB Port
Six USB 2.0 compliant ports are provided. Three ports are routed to front panel con-
nectors; three ports are routed to rear I/O through the J5 connector.
1.2.10 LEDs
Four LEDs are provided on the front panel as follows:
1.2.11 Watchdog Timer
An onboard watchdog timer provides system reset capabilities via software control.
The programmable time interval is from 1 to 255 seconds.
Table 1.3: LED Indicator for the MIC-3397
Function Color Indicator
Hot Swap Status Blue The board can be safely removed from system
HDD Status Yellow HDD is activity
Power Status Green The power is provided to the board.
Master/Drone mode status Green
LED On-> “Master” mode.
LED Off-> “Drone” mode.