28
Pole-Type 2nd Display Module Installation
1.
Turn off the system power properly through the operating system, then turn off any external
devices.
2.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
Regardless of the power-on state, voltage is always present on the main board as
long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the system.
3.
Secure the pole-type 2nd display module with four screws.
4.
Pass the pole-type 2nd display module’s cables through the guide hole as shown below.
Summary of Contents for EP-55XX-AR10
