Advantech ADAM-4570W, User Manual, Page: 59 / 62

53 Appendix A
A.2 Via Diagnostic Infrastructure Mode (without
wireless module)
1. Set the switch of ADAM-4570W/4571W to Normal Mode , then
power on.
2. Wait for 10 to 20 seconds until the signal quality is stable.
3. Adjust the switch to Diagnostic Mode , then wait for 5 seconds
until the signal quality is blinking.
4. Return the switch to Normal Mode , then ADAM-4570W/4571W
will reboot automatically with Diagnostic Infrastructure Mode.
Now ADAM-4570W/4571W will automatically search the field
site for access points and create a connection to the one with best
signal quality.
5. Start the Configuration Utility tool on your host PC (ensure your
host PC and the possible access points that ADAM-4570W/4571W
can connect to, are in the same network). Find the ADAM-4570W/
4571W on the network.
6. Reset the network setting as required. (About Network settings,
please refer to section 3.2.3 of the manual)
7. Power off ADAM-4570W/4571W, confirm the switch is on Nor-
mal Mode , then reboot it to finish the wireless connection. Now
you can configure and set up port mapping through an access point
(You can connect to the access point by WLAN or Ethernet).