ADVANTAGE AIR MyAir, Installation Manual

Page: 11 / 23

Installation Guide V1.2
9
8 - MITSUBISHI ELECTRIC (CB7 ME) SETUP
CB7 ME setup steps are as follows:
Optional: Connect a Mitsubishi remote control and check the unit works, before
installing MyAir controls.
1. Ensure power to the air conditioner & controls is off.
2. Check that the Mitsubishi Electric wired remote control is not connected to the
system.
3. Connect the supplied cable from the CB to the indoor unit. Wire the cable cores
to the terminals as shown below:
CABLE CORE COLOUR INDOOR UNIT TERMINAL
RED 1
BLACK 2
4. Go to Section 15 SYSTEM CONFIGURATION to complete install
9 - SAMSUNG (CB7 BDSAM) SETUP
CB7 BDSAM setup steps are as follows:
1. Connect the Samsung wired remote ( MWR-WE10N ) to the indoor unit in the
roof space.
IMPORTANT: This is a required step, the unit will not run without fi rst connecting
the Samsung remote.
2. Run the unit & test correct operation of indoor & outdoor unit.
3. Connect the supplied cable from the CB to the indoor unit. Wire the cable cores
to the terminals as shown below:
CABLE CORE COLOUR INDOOR UNIT TERMINAL
RED F3
BLACK F4
4. Go to Section 15 SYSTEM CONFIGURATION to complete install