2
5-Minute QuickStart
Advanced Motion Controls · 3805 Calle Tecate, Camarillo, CA 93012
Phone: 805-389-1935 · Fax: 805-389-1165 · www.a-m-c.com
5
Let’s spin the motor!
This quick setup procedure will get the motor moving in a short amount of time without the
need for a controller. The drive has been pre-configured in voltage mode with a slight
offset. This will turn the motor at a slow steady speed on power-up to demonstrate
operation. Once the system is shown to be operational, the next section Integrating
QuickStart into your System will guide you through the process of integrating the system
into your application.
Wiring
On page 7, you will find the cables and connections sheet. Use this as a reference when
following the steps in this section.
Drive
Connect cable CBL-D01 to the P1 connector on the drive. Connect the other end to the C2
connector on the system interface board (SIB).
Motor
Connect the white connector on the motor to the corresponding connector on cable CBL-
P01-10. Connect the red and black wires to the P2 connector on the drive.
Black
Motor -, P2-1
Red Motor
+,
P2-2
System Power
With the power supply turned OFF, connect the main power supply to the drive.
REVERSING THE POLARITY WILL DESTROY THE DRIVE. High Voltage goes to P2-5 and
ground goes to P2-4.
Grounding
Bring all ground wires to a central point ground such as a ground bus, ground plane or a
single ground bolt. Also don't forget to ground the drive chassis! Use the silver screw
marked PE on the case.
Motor Ground – The green wire coming from motor power cable is the motor chassis
ground. If the motor is already grounded through direct contact with the machine housing,
then leave the green wire disconnected. Grounding the motor at both the green wire and
at the motor case causes a ground loop that has been shown to disrupt the feedback
signals. Choose one or the other.
ELECTROMATE
Toll Free Phone (877) SERVO98
Toll Free Fax (877) SERV099
www.electromate.com
Sold & Serviced By:
