Epoch-M1C RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document
Page 13 of 38
the Epoch-M1C’s USB port (located on the right side of the repeater) and
the other end to the PC’s USB port as shown in Figure 2.
** Install the USB driver and the Epoch-M1C Manager Software prior to
installation.
5. Turn On the Power for Epoch-M1C
Make sure that the donor and server antennas and the power cable are
securely connected to the correct ports. Turn on the power switch,
located on the right side of the repeater.
6. Launch the Epoch-M1C Software
Open the Epoch-M1C Software. You will see the Status Menu.
** For more detailed information on the Epoch-M1C Software, please
refer to
Section 2 on page 15.
** If only one or both of the LEDs are not blinking: (1) check the physical
USB cable connection or (2) check if the repeater power is turned on.
7. Go to the Install Window
Now with the blinking TX and RX status LEDs on the Status Window, go to
the Install Window. You will see the following:
8. Select the Desired Band(s)
From the Install Window (Figure 3), click on the desired band(s)
(depending on which model you use, the corresponding band(s) will be
highlighted).
Figure 3 - Installation Window of the Epoch-M1C Software
