Page 20
ES/ESH-LT209_10152019
Single Stage Unitary Range
INSTALLATION
Side Reflectors & Bottom Shields
•
If used, install side shields (reflectors) and/or bottom shield as required. Refer to Figure 21 and Figure 22
for details.
•
Side shields are 124” (315cm) long. Fasten one side shield per reflector with #8 x 3/8” screws. Use three
side shield brackets per side shield. Space about 48” (122cm) apart, refer to Figure 21.
REFLECTOR HANGER
REFLECTOR
SIDE REFLECTOR
SIDE REFLECTOR BRACKET
(APPROX. 48" APART)
TIGHTEN NUT
REFLECTOR
SIDE REFLECTOR
BRACKET
SIDE REFLECTOR
SIDE REFLECTOR
RETAINER CUP
#8 X
3/8
" SCREW
(NOT SUPPLIED)
#8 X
3/8
" SCREW
(NOT SUPPLIED)
NOTCH THE SIDE
REFLECTOR FOR
REFLECTOR BRACKETS
AND HANGERS
NOTE:
CLOSE ALL CHAIN LINKS “S” HOOKS,
J BOLTS AND TURNBUCKLES
OR ANY OPEN CONNECTION
USE THE HOLE AS A GUIDE TO
POSITION SIDE REFLECTOR. THE
SIDE REFLECTOR EDGE MUST BE
VISIBLE THROUGH THE HOLE AT
ROOM TEMPERATURE.
SCREWS TO BE INSTALLED FROM INSIDE OF SIDE
REFLECTOR. INSTALL SCREWS ON ONE END OF THE
RETAINER CLIP TO ALLOW MOVEMENT.
Figure 21: Side Shield Installation
Summary of Contents for ES/ESH Series
Page 2: ......
