Page 18
ES/ESH-LT209_10152019
Single Stage Unitary Range
INSTALLATION
Elbow and U-Bend Installation
•
If required by the heater layout, install 90° elbows or U-bend tubes where indicated. Refer to Figure 19 for
details.
Note:
Elbows or U-bends are typically installed without reflectors. To reduce the above clearance to combustibles
distance use miter reflectors (see Figure 20) and refer to
Clearance to Combustibles
information.
ENDCAP
COUPLINGS
HANGER
LOCATION
HANGER
LOCATION
ENDCAP
HANGER LOCATION
COUPLINGS
ELBOW DETAIL
U-BEND DETAIL
Figure 19: 90° Elbow and U-Bend Assembly Detail
•
Elbows or U-bend tubes must be located not less than 10’ from the burner in ES/ESH-100 and smaller
models, not less than 15’ from the burner in ES/ESH-125 to ES/ESH-150, and not less than 20’ from the
burner in ES/ESH-175 and larger models.
Summary of Contents for ES/ESH Series
Page 2: ......
