21
Step 5: (for the T-300 only) Press and hold the <Jog - > button until the perforation that was just
centered on the heater bar reverses to the pinch roller fingers.
Step 5: (for the T-375 only) Press and hold the <Jog - > button until the perforation is centered under the
blue rubber roller but is still pinched between the rollers.
Step 6: Press the <Max Seal> button.
Note: If you perform these steps incorrectly, repeat from Step 1.
When complete, test the Seal Point setting by entering .1" and pressing the MC button. The bag should
feed so that the perforation is approx. 1/8" from the center of the heater bar.
Also, since the procedure also set the maximum reverse value, enter 6" in the Max Reverse setting. If
equipped with a Standard Frame bagger, this setting will be approx. 1.8" when the Seal Point Setting is
.1". On a Drop Frame machine, the maximum setting will be approx. 2.7" when the Seal Point Setting is
.1". Press the MC button and ensure that the bag does not reverse to far, to drop inside the machine.
3.31 Information Screens / Message Screens
If an error occurs the Touchscreen program will notify the operator with a red Warning Signal. For
specific problems, detailed messages will appear with solutions to fix a specific problem. See Fig. 3-40
through Fig. 3-53.
Some messages provide functional messages that describe errors or the status of equipment and some
provide instructions for operators to follow to bring the bagger back online. To reset a message screen,
clear the condition first (if required) and then touch the screen.
