Operation
4-5
3. Pull the film from the upper rear station down under the idler roller directly behind the nip roll and
over the top of the top nip roll. Separate the release liner and pull back. Stick film to feeder stock.
4. Route release liner up behind top roller and then tape to underside of windup core.
5. Set the speed potentiometer to a low setting an move to the rear of the machine.
6. Set the machine to run in the FWD direction and press the foot switch. Do not run film through
nip rolls without substrate of some kind, the adhesive will stick to nip rolls.
7. If you are doing top and bottom pressure sensitive, load the lower stations the same as the upper
stations. See web diagram below.
Figure 4. Pressure Sensitive Process