ADTRAN T3SU 300, User Manual

Page: 34 / 145

Chapter 2. Installation and Operation
34 T3SU 300 User Manual 61202217L1-1B
2. After the flanges have been installed, position the T3SU 300 at
the correct location within the rack and secure the mounting
flanges to the mounting rails of the rack.
3. Make all network, DTE, and power connections to the rear of
the unit. See Power Up on page 32 for more information on
making the DC power connection.
4. Using the 8-position modular to DB-25 female connector and
the 8-position modular to 8-position modular cable, connect a
VT100 terminal device to the
CONTROL
interface jack on the
front panel of the unit.
Desktop Installation
Follow these steps when using your T3SU 300 as a desktop unit:
1. Affix the four adhesive-backed rubber feet to the bottom of the
unit, one in each of the four corners. The feet should be placed
approximately one inch from the front or back and one inch
from the sides of the unit
2. Make all network, DTE, and power connections to the rear of
the unit. See Power Up on page 32 for more information on
making the DC power connection.
3. Using the 8-position modular to DB-25 female connector and
the 8-position modular to 8-position modular cable, connect a
VT100 terminal device to the
CONTROL interface jack on the
front panel of the unit.
REAR PANEL
The T3SU 300 is equipped with three option card slots, a built-in
HSSI interface, an alarm output terminal block, an auxiliary (AUX)
Be sure to install the flanges with the screw provided.