ADTRAN MX3216, System Manual

Page: 44 / 190

MX3216 System Manual
3-16 61189008L1-1B
Setup
The following steps describe the setup for the remote management of other systems using
terminal server ports application.
1. Setup remote management for the MX3216 system using the setup for the “MX3216 with
Remote Management Application” on page 3-11.
2. Connect the MX3RMM terminal server port to the RS-232 craft port of the other
equipment. Table 3-5 shows the pin assignments for each of the RS-232 interfaces.
NOTE
Obtain RJ-45 to DB9 adapters from a third party vendor (i.e.,
Kycon P/N KLA-ADTR-DB9M).
3. The default setting for the terminal server ports is 9600 bps with no parity. If this setting
does not match the craft port setting of the other equipment, then change the setting on
the Terminal Server menu under Provisioning of the MX3RMM.
4. Establish a Telnet session to the MX3216 with the port number for the particular port to
access the other equipment. The port numbers default to 2023, 2024, 2025, and 2026,
respectively, for each of the four ports. Once the session is established, the default
username for each port is “port #” (where # is the number of the port), and the default
password is “password”.
Table 3-5. PORT 1-4 Terminal Connector Pin List
RJ-45 Pin Port 1-4 DB9 Pin Signal
1 5 GND
2 NC NC
3 3 TXD
4 NC NC
5 2 RXD
6 NC NC
7 NC NC
8 NC NC