ADTRAN ATLAS 810 Plus, User Manual

Page: 132 / 188

Chapter 11. SNMP Management
11-2 ATLAS 810
PLUS
User Manual 61200266L1-1
SNMP TRAPS
An SNMP trap is a message sent by a network device, such as the
ATLAS 810
PLUS
, to report an operational anomaly or alarm condition.
Trap Destination List
A trap destination list contains information about sites designated to receive
SNMP traps. You can configure this list via a Telnet session or the VT-100
terminal menu. The ATLAS 810
PLUS
supports up to four trap destination
lists. By default, the destination list is empty.
Configuring a Trap Destination List via Terminal Menu
To configure the trap destination list, from the terminal menu select
System Config / SNMP / Traps Destination . Then enter your information,
similar to that shown in Table 11-1. (See also, Traps Destination on page 6-10.)
.
IP Address is the address of the network management station to which
ATLAS 810
PLUS
sends the trap. Community is the trap community-name
used for the selected network device. Trap Filtering is a record allowing you
to assign thresholds to each category of the ATLAS 810
PLUS
events.
Table 11-1. Trap Destination List
IP Address Community Trap Filtering
0 0.0.0.0 public [+]
1 0.0.0.0 public [+]
2 0.0.0.0 public [+]
3 0.0.0.0 public [+]