Adtech CNC9640, Programming Manual

Page: 94 / 161

ADTECH9 Series CNC Programming Manual
2.6 Probe G command
2.6.1. G31.1
Command for external signal detection jump
Format: G31.1 X_(Y_ Z_ A_ B_ C_) P_ F_
X(Y_ Z_ A_ B_ C_): When searching the distance, relative quantity is provided with a symbol. Search in the
positive direction when it is a positive number, and search in the negative direction when it is a negative
number.
P: The external signal input point, the signal is valid if it is connected with 0V, and stops when a signal
deceleration is detected. Reduce the search speed if the precision position is required. .
F: Search speed
2.6.2. G31.2
Extend G31.2 command to search for tool setting function
Format: G31.2 X_(Y_ Z_ A_ B_ C_) F_ P_ Q_ L_
Z: Search for the position of tool regulator Z
F: Search for the speed of the tool regulator
P: Tool setting input point for tool regulator
Q: Limiting input point of the tool regulator
L: Effective level of the tool setting point and limit point
2.6.3. G31.3
Extend the G31.3 command, to read the distance between the two detection switches
Format: G31.3 X_(Y_ Z_ ) P_ Q_ L_ D_
Command introduction: X: 0: move in negative direction 1: move in positive direction
P: X-axis, corresponding detection switch input port
Q: Y-axis, corresponding detection switch input port
L: Detection port input level
D: spindle encoder input detection axis number, 3: indicates that the Z-axis encoder input is detected,
and the main encoder line number and gear ratio are set according to the spindle parameters;
H: The minimum deviation value
Deviation save parameters, saved in #100