ADRF PSR-VU-9537-UA, Manual

Page: 26 / 60

Advanced RF Technologies, Inc. 26
5. REPEATER INSTALLATION
5.1 Installation Procedures
5.1.1 Wall Mount Procedure

Verify that the PSR-VU-9537-UBand mounting holes are in good condition

Place the PSR-VU-9537-UBmounting bracket template up against the wall and mark off mounting holes

Drill the appropriate size holes and install the included wall anchors

Remove the wall mount bracket from the repeater and bolt the wall mount bracket to the wall

Place the repeater onto the wall mount bracket and secure the bracket to the repeater

Connect the GND cable

Connect the Antenna cables

Connect the Power cable
Figure 5-1 Wall Mount
5.1.2 PSR-ANN Annunciator Installation
The PSR-ANN annunciator box has been designed to either mount on top of the PSR-VU-9537-UBrepeater or
can also be wall-mounted separately. By default, the mounting bracket is configured to mount to the top of the
repeater with the mounting bracket at the bottom of the PSR-ANN annunciator box. If individually wall mounting
the PSR-ANN, then the bracket will need to move from the bottom of the box to the back of the box.
Once the PSR-ANN annunciator box has been securely mounted, connect the included power/data cable from
the side of the PSR-ANN box to the port labeled Annunciator on the PSR-VU-9537-UA.
Wall Mount
Bracket