60
aTCA-9710
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow devices
may require more than 1 stop bit. Set this value to
1, 2
.
Flow Control
Set this option to select Flow Control for console redirection.
The settings for this value are
None, Hardware RTS/CTS
.
VT-UTF8 Combo Key Support
Enable VT-UTF8 Combination Key support for ANSI/VT100 terminals.
The settings for this value are
Enabled/Disabled
.
Recorder Mode
Enabled this mode, only text will be sent. This is to capture terminal data.
Set this value to
Enable/Disable
.
Resolution 100x31
Set this option to extended terminal resolution. Set this value to
Enable/Disable
.
Legacy OS Redirection
On Legacy OS, the number of rows and columns supported redirection.
Set this value to
80x24, 80x25
.
Putty KeyPad
Select function key and keypad on putty.
Set this value to
VT100, LINUX, XTERMR6, SCO, ESCN, VT400
.
Redirection After BIOS POST
The settings specify if BootLoader is selected than legacy console redirection is
disabled before booting to legacy O.S. Default value is Always Enable which
means legacy console redirection is enabled for legacy O.S.
Set this value to
Always Enable, BootLoader
.
Summary of Contents for aTCA-9710
Page 7: ...7 aTCA 9710 1 2 Block Diagram ...
Page 41: ...41 aTCA 9710 Step 3 Push the ejector handles inwards until it is locked ...
Page 42: ...42 aTCA 9710 Step 4 Lock both ends of the captive screws ...
Page 45: ...45 aTCA 9710 Step 3 Pull the blade outwards from the chassis until it is removed ...
