ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 10
DNST - This mode can be used as a precaution mode, that
in case the DMX signal is lost, interrupted, or power is lost, the operating mode chosen in the
setup is the running mode the fixture will go into when the DMX signal is lost. You can also set
this as the operating mode you would like the unit to return to when power is applied.
1. Press the MENU button until “DNST” is displayed, and either “PRSE”, “BLND”, or “LAST” will be
displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose
an operating mode you would like the unit to start up in when power is applied or the DMX signal
is lost.
• PRSE (Primary Secondary) - If the DMX signal is lost or power is applied, the unit will
automatically go into Primary Secondary mode and run a built-in show.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• LAST - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is
applied and this mode is set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
LED - With this function the LED display will turn off after 2 minutes
1. Press the MENU button until “LED” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” to
keep the LED display on at all times, or “OFF” to allow the LED display to turn off after 2 minutes.
Press any button to turn on the LED display again.
3. Press ENTER to confirm and exit.
DISP - This function will reverse the display 180º.
1. Press the MENU button until “DISP” is displayed, press ENTER.
2. Press the UP button to select “DSIP” to invert the display, or select “DISP” to keep the display in
the normal, upright orientation.
3. Press ENTER to confirm.
TEST - This function will run a self test program.
1. Press the MENU button until “TEST” is displayed, press ENTER.
2. The fixture will now run a self test.
FHRS - With this function you can display the running time of the unit.
1. Press the MENU button until “FHRS” is displayed, press ENTER.
2. The display shows the running time of the unit. Press MENU to exit.
VER - Use this function to display the Software version of the unit.
1. Press the MENU button until “VER” is displayed, press ENTER.
2. The display will show the software version.
Revo 4 IR
System Menu