14
OPERATING INSTRUCTIONS
Gamma Correction: With this function, you can optimize the brightness of the fixture. This is used
mainly when recording with an HD video camera. The brightness will be slight to the naked eye, but
looking through the lens of a camera it will be noticable.
1. Plug the fixture in and press the UP or DOWN buttons until “Menu Function” is displayed. Press
the ENTER button.
2. Press the UP or DOWN buttons to scroll to “Gamma” and press ENTER.
3. Use the UP or DOWN buttons to switch between the different gamma settings.
4. Press ENTER to confirm your selection or press the MODE button to exit and return to the main
menu.
Software Update (USB Data): This submenu is used for any future software updates. Check online
at
www.adj.com
for any software updates. Download the software update to a flash stick and plug
the flash stick into the Flash Drive slot located on the side of the unit.
NOTE: Contact ADJ customer service for help and guidance when updating software.
Default Running Mode: This is a default running mode. When this mode is activated all modes will
return to their default settings.
1. Plug the fixture in and press the UP or DOWN buttons until “Menu Function” is displayed. Press
ENTER.
2. Press the UP or DOWN buttons to scroll to “DFSE” and press ENTER.
3. Press the UP and DOWN buttons to switch between “ON” or “OFF”. To reset the unit to factory
settings select “ON” and press ENTER. Press the MODE button to exit the submenu with no
changes.
Time Infomation: In this submenu you are able to check the current running time, total running time,
last time the running time was cleared, and clear the running time.
1. Plug the fixture in and press the UP or DOWN buttons until “Info” is displayed.
2. Press the ENTER button and press the UP or DOWN buttons until “TimeInfo” is displayed, and
press ENTER.
3. Use the UP or DOWN buttons to find the time information you would like to check. Press the
ENTER button to access your desired time information.
4. To clear the current running time, press UP or DOWN buttons until “TimerPin” is displayed, and
press ENTER. Use the UP or DOWN buttons to enter in the password “050”, a press ENTER.
5. Use the UP or DOWN buttons to select “ON”, and press ENTER.
6. Unplug the fixture, then plug it back in. The current running time should now be cleared.
7. Press the MODE button to exit and return to the “Infor” menu. Press MODE again to exit and
return to the main menu.
Temperature Infomation: In this submenu you are able to check the fixture’s current running tem-
perature.
1. Plug the fixture in and press the UP or DOWN buttons until “Info” is displayed.
2. Press the ENTER button and press the UP or DOWN buttons until “TempInfo” is displayed. Press
ENTER.
3. Use the UP or DOWN buttons to find the time information you would like to check. Press the
ENTER button to access your desired time information.