Ender 3 Belt Kit assembly manual
P a g e
29 | 43
14
M4 SLOT NUT
2
Kit
✓
Insert Flange Bearing 12mm on both sides of one of the Roller:
✓
Insert Block Bearing 12mm on both sides of the other Roller:
✓
REAR ROLLER MOUNT:
Take the ROLLER with FLANGE BEARINGS on it, install it with
M6x18 SCREWS and M6 NYLOCK NUTS, please be aware in this step belt have to be
inserted as shown in the next picture. Secure both FLANGE BEARINGS by adjusting its
screws to hold it in place.
ROLLER HAS TO BE CENTERED!
At this point, no alignment is required, since it is mounted into round exact holes on
the side plates:
