Ender 3 Belt Kit assembly manual
P a g e
34 | 43
Figure 48 Heatbed base plate without wheels and showing aligned holes pairs.
✓
Installing support bars for heatbed:
Using
1020 ALU PROFILE 326mm
and
M5x8 Screw
(04) and
M5 Slot Nuts
(04), fix the heated base plate with the mentioned bars, as
shown in the next picture:
Note:
You might end up with a 90° rotated heatbed base plate (compared with its
original direction), but that’s totally fine.
Figure 49 1020 Alu profiles must be centered with Heatbed base plate.Check for aligned holes pairs. Distance
between Alu bars must be 40 mm.
✓
Installing heatbed Assembly:
Install heat bed element back again holding with Screws
and leveling nuts, compress the springs almost half their size.