Define the condition of peak search to search all kinds of peak. It can only be judged as peak
when meanwhile meets the value of both “peak excursn” and “peak thresh”.
1) Peak Excursn
Specify the difference value between peak and minimum amplitude on left and right side. The
difference value which is higher than peak excursn can be judged as peak.
Parameter
Instruction
Default
10 dB
Range
0 dB ~ 200 dB
Unit
dB
Knob Step
1 dB
Direction Key Step
1 dB
2) Peak thresh
Specify the minimum value of peak amplitude. The peak which is higher than peak thresh can be
judged as peak.
Parameter
Instruction
Default
-90 dB
Range
-200 dBm ~ 0 dBm
Unit
dBm,-dBm,mV,uV
Knob Step
1 dBm
Direction Key Step
1 dBm
3) Peak Search
Set the peak which is looked up in peak search is whether the maximum value on the trace or the
peak meets search parameter.
•
Choose “Max Value”, then look up the maximum value on the trace.
•
Choose “Parameter”, then look up the peak meets the condition of search parameter on the
trace.
•
This set is only valid for the peak search excecuted when press “Peak”.
3.4 Shortcut Key
3.4.1 Auto
Search for signals automatically throughout the full frequency range and adjust the frequency
and amplitude for optimum display effect of the signal, thus realizing one-key signal search and
auto setting of parameters.
Before Auto Search
:
Summary of Contents for DSA2016
Page 1: ...USER S MANUAL Handheld Spectrum Analyzer DSA2016TG DSA2016 V1 0 0 ...
Page 7: ...Chapter1 Quick Start u Instrument Introduction u General Check u Preparation ...
Page 15: ...2 3 2 Left Panel Left Panel 5 Headphone Connects to a headphone 6 SD card slot 5 6 ...
