2.
Open the cover of the recovery tank.
3.
Rinse the tank with a water jet.
SUCTION FILTER CLEANING
1.
Open the cover (1) and unscrew the knob (2) to release the filter
protection (3).
2.
Rotate the filter protection clockwise to release it.
3.
Take off the filter and
the filter protection.
4.
Clean all parts with a
water jet especially the
inside surfaces and the
filter bottom.
5.
Carry out cleaning
operations carefully.
6.
Reassemble all parts.
MANUAL DISASSEMBLY OF THE BRUSHES
With the brushes base in lifted position, turn the brush in the rotating
sense as indicated in the figure, until it is released from the brush
holder plate seat. The figure shows the rotating sense for the release.
AUTOMATIC DISASSEMBLY OF THE BRUSHES
1.
Turn the key (1) clockwise to switch on the machine.
2.
Press the push button (2) of up/down brushes base to lift the
brushes.
3.
Press simultaneously the push buttons (3) and (4) and then press
just once the push button (2).
Move the machine before taking the brushes in order to avoid injuries.
BRUSHES CLEANING
Disassemble the brushes and clean them with a water jet (check under
paragraph of “BRUSHES DISASSEMBLY”).
SQUEEGEE CLEANING
Keeping the squeegee clean guarantees always the best drying result.
For its cleaning it is necessary to:
1.
Take off the squeegee hose (4) from the coupling.
2.
Disassemble the squeegee from its support (1) by loosening the
knobs (2) counterclockwise and making slide the threaded parts in
the appropriate slots up to their release.
3.
Clean with care the internal part of the squeegee inlet eliminating
eventual dirt residuals.
4.
Clean with care the squeegee rubbers.
15