ADJUSTMENT OF THE SQUEEGEE
In order to have a perfect drying result through the squeegee, the rear
rubber must have the lower bending uniformly adjusted in all its
length. For the adjustment, it is necessary to put oneself in working
condition and therefore the suction motor has to be switched on and
the brushes have to function together with the detergent solution.
The bending is not uniform
Adjust the squeegee inclination rotating counterclockwise the wing nut
(1) to increase the bending in the central part, or clockwise to increase
the bending on the extremities.
Height adjustment
Once that the squeegee inclination has been adjusted, it is necessary to
fix this optimum condition making touch slightly the wheels onto the
floor. Release the wheels rotating counterclockwise the register (2),
rotate the register (3) to raise or to lower the wheels until the desired
bending is reached.
At the end block again the wheels through the register (2).
SPLASH GUARD ASSEMBLY
The two splash guards have to be assembled onto the brushes base
group. Insert the metal strips inside the suitable slots present on the
rubber. Place the hole at the flat extremity of the strip onto the screw
placed in the front of the cover. Secure the strips with the nut.
Screw down the knobs in the rear part of the cover in the free
extremity of the metal strips. The operation has to be carried out for
both splash guards. With the brushes assembled, the splash guard must
slightly touch the floor.
BRUSHES ASSEMBLY
To assemble the brushes, proceed as
follows:
1.
Switch on the machine turning
the key (1) clockwise.
2.
Press the push button (2) of
up/down of the brushes base
to lift the brushes.
3.
Take off the electric supply by
turning the key (1)
counterclockwise.
With the brushes base group in lifted position, insert the brushes into
their plate seat underneath the brushes base turning them until the
three metal buttons are properly seated in their slots; rotate
energetically the brushes to push the button towards the coupling
spring until they get blocked.
The figure shows the rotating sense for brushes coupling.
For a longer life of the brushes we suggest to invert daily their position.
Whenever brushes were deformed we suggest to reassemble them in
the same position, avoiding that the different inclination of the bristles
causes excessive motor overload or troublesome vibrations.
Use only brushes supplied with the machine or the ones indicated in
the paragraph “RECOMMENDED BRUSHES”. The use of other brushes
can compromise security.
STANDBY MODE
After 10 minutes of inactivity, if the machine is on, it goes in stand-by
mode and the display turns off. To start again press any button on the
instrument board, the display will turn on again and after few seconds
the machine returns operative.
11